Nmap com scan para IPv6

CaioSerrano
(usa BackTrack)

Enviado em 13/03/2011 - 12:14h

Fala Galera,

Bom, a minha duvida é o seguinte: estudando um pouco mais sobre o IPv6, tentei passar um scan com o nmap e parece que ele "enxerga" as porta com suporte a IPv6, o que pode ser?

#ifconfig
eth0 Link encap:Ethernet HWaddr 00:25:22:42:d2:7a
inet addr:192.168.0.2 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::225:22ff:fe42:d27a/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:110557 errors:0 dropped:0 overruns:0 frame:0
TX packets:71340 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:160475943 (160.4 MB) TX bytes:6438640 (6.4 MB)
Interrupt:26 Base address:0xc000
------------------------------
Nmap -6 -sV -v ::225:22ff:fe42:d27a

Starting Nmap 5.35DC1 ( http://nmap.org ) at 2011-03-13 12:14 BRT
Nmap scan report for ::225:22ff:fe42:d27a
Host is up.
All 1000 scanned ports on ::225:22ff:fe42:d27a are filtered

Service detection performed. Please report any incorrect results at http://nmap.org/submit/ .
Nmap done: 1 IP address (1 host up) scanned in 0.18 seconds
--------------------------
Nmap -6 -sV -v

Starting Nmap 5.35DC1 ( http://nmap.org ) at 2011-03-13 12:15 BRT
Nmap scan report for ip6-localhost (::1)
Host is up (0.00026s latency).
Not shown: 998 closed ports
PORT STATE SERVICE VERSION
22/tcp open ssh OpenSSH 5.1p1 Debian 3ubuntu1 (protocol 2.0)
2121/tcp open ftp ProFTPD 1.3.1